在安装时,严禁用铁锤等击打,reducer生产,****轴向力或径向力过大损坏轴承或齿轮。一定要将安装螺栓旋紧之后再旋紧紧力螺栓。
At the time of installation, it is strictly prohibited to use a hammer,reducer报价, such as a hammer, so as to prevent the axial or radial force from damaging the bearing or gear. It is necessary to tighten the bolt when the bolt is tightened.
减速机内部齿轮齿形修整(修缘和修根)和齿顶倒角 将齿顶的齿形切削成比正确的渐开曲线略呈凸形。当齿轮齿面受外力产生变形时,辽宁reducer,可以避免对与之啮合的齿轮产生干涉,reducer哪家好,并且可以降低噪音,延长齿轮寿命。
The internal gear of the reducer is trimmed (trim and trim) and tooth top chamfering to make the tooth shape of the tooth top convex than the correct involute curve. When the gear tooth surface is deformed by external force, it can avoid interference to the gears engaged with it, and can reduce noise and prolong the service life of gears.
安装前确认电机和减速机是否完好无损,并且严格检查电机与减速机相连接的各部位尺寸是否匹配,这里是电机的*凸台、输入轴与减速机凹槽等尺寸及配合公差。
Before installation, confirm whether the motor and reducer are in good condition, and strictly check whether the size of each part of the motor connected to the reducer i*atch. Here is the size and fit tolerance of the motor"s locating lug, input shaft and reducer groove.