UVC 检测185nm强度功率检测仪 半导体面板厂用
20W高量程紫外线功率计银线系列
（可用于测量20 W/cm2以上的LED光源）
紫外强度单位：mW/cm2 毫瓦/平方厘米
双通道x1/x10
自动开关
可充电电池
此款紫外线功率计是高质量的紫外测量仪器。
它用于测量紫外线发光强度。
测量单位为mW/cm2，用来比较和检查紫外线光源发光的均匀性。
应用领域：*设备，印刷喷涂，防晒用品，涂装固化，医疗生物等。
产品特点：
为了节省电池能量，银线紫外线功率计使用后会自动关闭一分钟。
银线紫外线功率计有各种不同的标准测量范围
在下订单前用户要根据具体要求选择一下不同波段：
6.2.1. UV-Meter Silver Line Diazo 350 – 460 nm
6.2.2. UV-Meter Silver Line UV-A 315 – 410 nm
6.2.21. UV-Meter Silver Line UV 380 – 420 nm
6.2.3. UV-Meter Silver Line UV-B 280 – 315 nm
6.2.4. UV-Meter Silver Line UV-C 230 – 280 nm
6.2.5. UV-Meter Silver Line Full UV 230 – 410 nm
6.2.6. UV-Meter Silver Line UV-V 395 – 445 nm
参数：
品牌：UV-DESIGN
型号：Silver Line Series
.大输入功率：2000W/cm2
波长：230-460 nm（可选）
环境温度：0—45℃
显示器：2x16位数显
.高功率可以检测到20 W/cm2，显示结果基于.大功率输入。
范围0 x 1：0 - 199,9 mW/cm2
范围0～10： 0 - 1999 mW/cm2
重量：约200克。
电源：3.7V可充电锂电池。
尺寸：140mm×70mmx 13mm
连接线线缆长度：1m
传感器尺寸:40 mm x 10 mm
精度：&plu*n;5%
探头可****度耐压
在传送带上.高可耐温132℃，不超过10S。
注意事项：为了保持精度准确，建议每年校准一次。更换电池后也有必要校正。
.重要的一条：.高功率可以检测到20 W/cm2，显示结果基于.大功率输入。
UV-Meter Silver Line Series
(also&nbilable for LED measurement up to 20 W/cm2)
+ UV intensity mW/cm2
+ 2 channel x1/x10
+&nb*uto off
+ re-chargeable&nb*ccu cell
The UV-Meter Silver Line is&nb* high quality UV measuring instrument.
It is used for the measurement of the intensity of UV light.
All measurements&nb*re expressed in mW/cm 2 in order to compare light sources&nbs*bsp;to check uniformity of the light
emission.
Typical&nb*pplication fields&nb*re the co*ol of units for the ex*ure of diazo, polymer, chromaline&nb*nd daylight films in
the graphic&nb*rts industry, suntan equipment, sterilisation units&nb*nd other fields of photo bioIogy.
Special feature:
In order to s*e battery energy, the UV-Meter Silver Line will turn off&nb*utomatically&nb*fter one minute.
The UV-Meter Silver Line is&nbilable&nb*s&nb* standard in various different measuring ranges*:
(Please state upon order)
6.2.1. UV-Meter Silver Line Diazo 350 – 460 nm
6.2.2. UV-Meter Silver Line UV-A 315 – 410 nm
6.2.21. UV-Meter Silver Line UV 380 – 420 nm
6.2.3. UV-Meter Silver Line UV-B 280 – 315 nm
6.2.4. UV-Meter Silver Line UV-C 230 – 280 nm
6.2.5. UV-Meter Silver Line Full UV 230 – 410 nm
6.2.6. UV-Meter Silver Line UV-V 395 – 445 nm
*further spectral ranges&nbilable upon request
The display re*gs&nb*re fictitiously. The basic setting is done by means of&nb* potentiometer.
Technical Data:
Max. Power input : sensor input 2000W/cm2
W*elength: 315 – 410 nm UV-A&nbs*bsp;other)
Temperature: 0 - 45 C
Display: 2x16 Digits
Range X 1 : 0 - 199,9 mW/cm2
Range X 10 : 0 - 1999 mW/cm2
Weight:&nb*pprox. 200 grams
Battery: 3.7 Volt LiPO Accu Cell
Dimensi*: 140 mm x 70 mm x 13 mm
Sensor cable: 1 meter
Sensor ∅ 40 mm x 10 mm
Base Accuracy: &plu*n; 5 %
The probe-type sensor of the UV-Meter can withstand max. 110° C / 132° F for up to 10 seconds. The temperature
of the housing should not exceed 45° C / 122° F.
Calibration:
In order to keep its full function&nb*nd precision it is recommended to h*e re-calibration done once per year. Recalibration will&nb*lso be necessary&nb*fter change of battery. Ongoing, PTB traceable calibration with certificate
*also&nbilable up to 20 W/cm2, display resolution in relation to maximum power input
